Menu
-
Washing & Storage
- Solid wood furniture
- CAT36
- Wooden decoration
- Wooden toys
Walnut veneered MDF panel 400x300x5mm
€12.95 Tax included5 1Whole Wood,5/ 5This walnut veneered MDF panel has an extraordinary look. It's ideal for engraving and laser-cutting.
For decorative purposes, this walnut paneling can be used to cover a surface for aesthetic appeal. For renovation, this veneer can be used to restore surfaces. For craftsmanship, veneer is used to create small pieces of furniture and other small objects.
Veneer panel dimensions: 40 × 30 cm
MDF panel thickness: 5 mm
Veneer wood type: walnut
Panel structure: MDF
Walnut panel finish: unfinished
Walnut veneer panel quality: A/B
Wood certification: FSC label
Veneer panels are for interior use only.
Here are the steps and techniques for placing veneer on a roll:
- Prepare the surface. The surface on which you're going to glue the veneer must be clean, smooth and free of dust and grease. Sand the surface if necessary to make it smooth.
- Choose a glue suitable for the wood and substrate (vinyl, neoprene or polyurethane glue).
- Apply the glue to the surface on which you'll be gluing the veneer. You can use a brush, roller or spatula (or glue gun). The entire surface of the wood should be glued. Not too much, to avoid excess and drips.
- Place the veneer on the surface, aligning edges and corners. Remove air bubbles if necessary.
- Use an iron or roller to press the veneer to the surface. Leave the weight on for the duration of the drying time.
- Allow to dry. This may take several hours or even days, depending on the type of glue you've used.
- Finish the job by cutting off any protruding ends with scissors or a cutter. Finish the surface and corners with fine-grain sandpaper (from 180)
You might also like
8 other products in the same category:
Oak veneer 600x165cm
€16.95Balsa sheets A4 2mm 5pcs
€19.16 €23.95-
Products from the same brand
- Solid wood furniture